Thomas O

No complaints, I removed 6 stumps. I put a new sidewalk from my house and the contractor said it was too close to a large tree to dig out with his Bobcat. I used the stump grinder and went over the entire area 12 inches deep and then used my loader on my tractor to remove the debree. Would have been impossible without it.

Scott S

The HM 122 works very well. It is fairly easy to set up and operate. I have experience with larger wood miser mills, but they are much more costly. This mill is a good value that delivers good results. I can recommend this mill without reservation.

Merle E

the assembly instructions were very easy to follow and very thorough. all of the parts were shipped with the mill . the mill works very well so far and it was a very good purchase

Brian S

Love the WC88! I use it non stop for 3 hours or more each time I work with it out in the woods. It’s a great product. It is attached to a 1975 John Deere 2630 with 75 PTO HP. The WC88 has no problems with chipping full trees. It’s a monster!

Seth K

This chipper has been an absolute joy to use. I have about 10 or 15 hours on it so far, chipping both hard and soft woods up to 5 inches in diameter. I just love sticking the butt end of a 25 foot tree into the WC68 and stepping back to watch it gobble down the whole thing. Attached to my John Deere 2038R (roughly 30 hp at the PTO), it has never bogged down or broken a shear pin. I did have to adjust the position of the top hook on my iMatch quick attach, making it the only implement I own that doesn't work with the original quick attach hook position, but that is a very minor inconvenience. Most importantly, it works beautifully at the job for which it was designed. Oh, also, Derek has responded to my few questions quickly and completely. I am very happy with this purchase! - Seth Krieger, Clermont, FL.

James H

Drove down to the business in Port Perry to pick this little number up. I was conflicted between the WC68 and the WC 88, but talked with Neil about my specific needs and ended up with the WC88 and couldn’t be happier. I was worried that it would be too much machine for my tractor (I have just under 40HP at the PTO) but I wanted the larger infeed and the infeed offset that’s on the WC88 so I could chip right into my dump trailer. So far, I’m thoroughly impressed. It eats anything and doesn’t bog down the tractor even when chipping larger branches (up 6” tested so far). A my son said, “it does what they claim it’s supposed to do.” High praise from him!

Roger P

This is the 2nd piece of equipment I have from woodland mills. The quality is 2nd to none. I use the chipper and the stump grinder on a Massey Ferguson gc1710 tlb, No issues at all. I am looking forward to getting a sawmill in the near future. Thank you

Leonard F

I love the machine. I have a Kubota B2320 with 18 HP at the PTO and it doesn’t even slow down. I only chip up to 3”. Anything larger than that I use for firewood. It is a solid well designed machine. Highly recommended.

Doug S

Works great looking at a saw mill next

John T

Mill was delivered on time & was easy to set up. Sawing wood the same day. Awesome product.